This specification covers an aluminum alloy in the form of extruded bars, rods, and profiles 0.250 to 2.000 .inches (6.35 to 50.80 mm) in nominal thickness and up to 32 in2 (206 cm2), inclusive, in cross-sectional area (see 8.5).
This specification covers an aluminum alloy in the form of extruded bars, rods, wire, profiles, and tubing 5.000 inches (127.00 mm) and under in nominal diameter or thickness (wall thickness of tubing) and 32 in2 (206 cm2) and under in cross-sectional area (see 8.4).
This specification covers established inch/pound manufacturing tolerances applicable to carbon and alloy tubing ordered to inch/pound dimensions. These tolerances apply to all conditions unless otherwise noted. The term “excl” is used to apply only to the higher figure of the specified range.
This SAE Standard gives guidance for - and specifies the requirements for - the electrodeposition of chromium for engineering purposes. It relates to both new articles and also the reclamation of worn or over-machined components. Chromium electrodeposition undertaken for decorative purposes is not considered herein.
This SAE Standard specifies the requirements for the electro-deposition of gold on ferrous-base materials, copper-base materials, aluminum-base materials, zinc-base materials and nickel-base materials for MOD use. It is primarily intended for use on electrical and electronic items which are to be plated with gold to: a Increase the electrical conductivity of the surface. b Provide a solderable surface.
This specification covers the general requirements for aluminum and aluminum alloy tube; drawn, seamless (see 6.1.1). Specific requirements for these products in a particular alloy are covered by the applicable detail specification (see 6.3).