Refine Your Search

Topic

Search Results

Standard

Phosphate Treatment of Iron and Steel

2017-10-04
CURRENT
AMS03_11A
This SAE Standard specifies requirements for the processing of iron and steel (excluding corrosion resisting steels) to produce coatings consisting essentially of inorganic phosphates, which are intended to be used in conjunction with supplementary finishes for the protection of the basis metal against corrosion (and in certain cases to give, additionally, anti-wear properties to sliding surfaces).
Standard

Electro-Deposition of Silver

2017-10-04
CURRENT
AMS03_9A
This SAE Standard specifies the requirements for the electro-deposition of silver on ferrous-base, copper-base, aluminum-base, zinc-base and nickel base materials. It is primarily intended for use on electrical and electronic items which are to be plated with silver to increase the electrical conductivity of the surface.
Standard

Electro-Deposition of Cadmium

2017-10-04
CURRENT
AMS03_19A
This SAE Standard specifies the requirements for the electro-deposition of cadmium on non-corrosion resisting steel items for protection against corrosion, and on copper based alloy items and corrosion resisting steel items for the reduction of contact corrosion of less noble metallic materials.
Standard

Molybdenum Disulfide, Technical, Lubrication Grade

2017-09-22
CURRENT
AMSM7866B
This specification covers the requirements for procurement of one grade of powdered molybendum disulfide to be used in lubricants and greases for surfaces where boundary conditions exist.
Standard

Treatment of Sheet Metal Parts Corrosion-Resistant Steel

2017-09-20
CURRENT
AMS2550F
This specification covers the engineering requirements for a treatment to provide enhanced corrosion resistance to sheet metal parts, such as brackets, spacers, and washers, fabricated from martensitic Corrosion-resistant steels, usually AMS 5504 or AMS 5508 and having hardness not higher than 40 HRC, or ferritic corrosion-resistant steels, usually AMS 5506. The treatment is not recommended for use on parts subject to impact in service.
Standard

Magnesium Alloys, Anodic Treatment of

2017-09-20
CURRENT
AMSM45202B
This specification covers the requirements for equipment, materials and procedures to be used in anodic treatments for magnesium base alloys for the purpose of increasing their corrosion resistance or producing surfaces suitable for the application of a protective organic finish.
Standard

Engine Gray Finishing Low Baking

2017-09-20
CURRENT
AMS2510F
This specification covers the engineering requirements for finishing aircraft parts and assemblies with an engine gray enamel.
X