Classification System for Rubber Materials

  • 2006-11-01
  • SAE International

Scope This classification system tabulates the properties of vulcanized rubber materials (natural rubber, reclaimed rubber, synthetic rubbers, alone or in combination) that are intended for, but not limited to, use in rubber products for automotive applications. The SAE Committe on Automotive Rubber Specifications (CARS) has the sole responsibility for SAE J200. CARS Works closely with and receives input from ASTM Subcommittee D11.30 on Classification of Rubber Compounds with the goal to keep SAE J200 and ASTM D 2000 technically equivalent. Candidate materials presented for development of new tables or for inclusion in Tables A1 or A2 of SAE J200 or Table X1.1 of ASTM D 2000 shall be initiated with the SAE CARS Committee. The procedure to be followed is detailed in Appendix C of SAE J200. This document may serve many of the needs of other industries in much the same manner as SAE numbered steels. It must be remembered, however, that this system is subject to revision when required by automotive needs. It is recommended that the latest revision always be used. This document is based on the premise that all rubber materials intended for use in rubber products can be arranged into characteristic designations. These designations are determined by types, based on resistance to heat aging, and classes, based on resistance to swelling by oil. Basic levels are thus established which, together with values describing additional requirements, permit complete description of the quality of all rubber materials. In all cases where provisions of this document would conflict with those of the detailed specifications for a particular product, the latter shall take precedence. When the rubber product is to be used for purposes where the requirements are too specific to be completely prescribed by this classification system, it is necessary for the purchaser to consult the supplier in advance to establish the appropriate properties, test methods, and specification test limits. Purpose The purpose of this document is to provide guidance to the engineer in the selection of practical, commercially available rubber materials, and further to provide a method for specifying these materials by the use of a simple line call-out designation. This document was developed to permit the addition of descriptive values for future rubber materials without complete reorganization of the classification system and to facilitate the incorporation of future new methods of test to keep pace with changing industry requirements.

Standard Published Revision Status
J200_201506 2015-06-19 Latest Revised
2011-12-12 Historical Revised
2008-05-15 Historical Revised
2006-11-01 Historical Revised
2005-01-13 Historical Revised
2003-11-13 Historical Revised
2001-12-10 Historical Revised
2001-01-01 Historical Revised
1998-03-01 Historical Revised
1997-04-01 Historical Revised
1996-07-01 Historical Revised
1994-06-01 Historical Revised
1993-05-01 Historical Revised
1992-06-01 Historical Revised
1991-06-01 Historical Revised
1990-06-01 Historical Revised
1989-06-01 Historical Revised
1988-02-01 Historical Revised
1987-05-01 Historical Revised
1986-06-01 Historical Revised
1985-05-01 Historical Revised
1984-01-01 Historical Revised
1982-06-01 Historical Revised
1978-12-01 Historical Revised
1969-01-01 Historical Revised
1963-06-01 Historical Revised
1962-05-01 Historical Issued
  • SAE J 200
SAE MOBILUS Subscriber? You may already have access.
Members save up to 18% off list price.
If you are currently using this technical report:
HTML for Linking to Page
Page URL

Related Items

Training / Education
Training / Education
Technical Paper / Journal Article
Training / Education