The SAE Standard covers normalized electric resistance welded, cold-drawn, single-wall, SAE 1021 carbon steel pressure tubing intended for use as pressure lines and in other applications requiring tubing of a quality suitable for bending, flaring, forming, and brazing. The grade of material produced to this specification is higher in carbon content and manganese content than the grade of material specified in SAE J525. The material produced to this specification is intended to service higher pressure applications than like sizes of SAE J525. Due to the higher carbon and manganese content, however, the forming characteristics of the finished tube is diminished somewhat when compared to SAE J525. Special attention to the overall forming requirements of the finished assembly should be taken into consideration when utilizing material produced to this specification.
This five year review of this standard resulted in changes identified by the bar on the left side of the page and are described as follows: a. Added SAE and other international standards to the "Related Publications" section because these documents are related to J2467 tubing. b. In Section 8. Performance Requirements, removed un-needed J1677 paragraph numbering to eliminate unnecessary confusion. c. In Section 8. Performance Requirements, added elongation test.